Grizzly G0716 - Manual (Page 24)

-22-
Model G0716 (Mfg. Since 2/11)
the proper installation of the sandpaper strip on
the drum is essential to ensure good sanding
results and prevent the sandpaper from coming
loose or tearing during operation.
items Needed Qty
hex Wrench 5mm .............................................. 1
replacement sandpaper strip .......................... 1
to replace the sandpaper strip:
1. disCoNNECt saNdEr FroM poWEr!
2. remove the cap screw that secures the
dust collection hood, then swing it up to gain
access to the sanding drum.
3. reach under the right lip of the drum and
push the clamping device so that the jaw is
aligned with the slot in the drum surface (see
figure 18).
Replacement
replacement sandpaper for the Model g0716 is
available in 3" bulk rolls (see
page 28 for options
from grizzly).
When fabricating a replacement sandpaper strip
from bulk rolls, either use the existing strip as a
template or refer to the dimensioning information
in
figure 17.
65 1 /
2
"
Full
Length
Before
Removing
End
Pieces
2 1 /
2
"
15 3 /
4
"
At an
Angle
Remove The
Gray Areas
On Both Ends
15 3 /
4
"
At an
Angle
3"
2 1 /
2
"
figure 17. replacement sandpaper dimensions.
figure 18. aligning right clamping device jaw
with the drum slot.
Clamping
device
Tip: To get two strips from a 10 ft. roll, cut the roll in the middle at an
angled as shown here.