Grizzly G0716 - Manual (Page 21)

Model G0716 (Mfg. Since 2/11)
-19-
test Run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following:
1) Both motors power up and run correctly, and
2) the safety disabling mechanism on the switch
works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
troubleshooting on page 30.
to test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Make sure the sanding drum is safely above
the conveyor belt so that it will not make con-
tact when running.
4. Verify that the machine is operating correctly
by turning it ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
5. rotate the conveyor variable feed rate dial
clockwise to verify the conveyor belt feed rate
changes, then turn it counterclockwise until
the belt stops.
6. turn the machine OFF.
7. remove the switch disabling key, as shown
in figure 15.
8. try to turn the start the machine with the
paddle switch.
—if the machine does not start, the switch
disabling feature is working as designed.
—if the machine starts, immediately stop the
machine. the switch disabling feature is
not working correctly. this safety feature
must work properly before proceeding with
regular operations. Call tech support for
help.
figure 15. removing switch key from paddle
switch.
For your convenience, the adjustments listed
below have been performed at the factory.
however, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
step-by-step instructions for these adjustments
can be found on the referenced page for each
item.
factory adjustments that should be verified:
• Conveyor belt tension and tracking
(
page 33)
• gib adjustment ( page 34)
• Conveyor belt to drum alignment ( page 35)
• pressure roller adjustment ( page 36)
• adjusting elevation stop ( page 37)
Recommended
Adjustments