Grizzly G0716 - Manual (Page 18)

-16-
Model G0716 (Mfg. Since 2/11)
6. slide the wheel axle through the brackets, put
the wheels onto the ends of the axle, then
secure them with the cotter pins by inserting
them through the axle holes and bending
back the ends.
7. attach the lifting handle assemblies on the
front legs with (4) M6-1 x 10 flat head screws
and M6-1 lock nuts, as shown in
figure 10.
5. attach the wheel brackets to the rear legs
with (4) M8-1.25 x 16 hex bolts and M8-1.25
lock nuts (see
figure 9).
Note: The left and right wheel brackets are
different configurations.
figure 9. Wheels assemblies.
x 4
Cotter pin
figure 10. lifting handle assemblies attached.
x 4
2. attach the bottom braces to the legs, as
shown in figure 7, with the remaining (16)
M8-1.25 x 12 carriage bolts and M8-1.25 lock
nuts.
figure 7. Bottom braces attached to the legs.
x 16
3. slide the leg foot pads onto the bottom of the
legs, as shown in figure 8.
figure 8. leg foot pad installed.
Foot
pad
4. Carefully turn the stand over, square up the
legs and braces, then fully tighten all fasten-
ers.