Grizzly G0716 - Manual (Page 39)

Model G0716 (Mfg. Since 2/11)
-37-
Adjusting Elevation
Stop
a phillips head screw that protrudes through the
bottom of the frame acts as a stop to prevent
the sanding drum from making contact with the
conveyor belt when adjusting the height (see
figure 38).
figure 38. location of the elevation stop.
screw &
hex Nut
to adjust the elevation stop screw:
1. Make sure the conveyor belt is properly
tensioned (refer to conveyor belt tension
& tracking on page 33 for detailed instruc-
tions).
2. disCoNNECt saNdEr FroM poWEr!
3. raise the sanding drum all the way up.
4. loosen the hex nut on the stop screw, then
adjust the height of the screw that protrudes
above the frame to be no less than
1 ⁄
4
".
5. re-tighten the hex nut, then lower the sand-
ing drum until the stop screw contacts the
motor mount frame.
6. Verify that the sanding drum is at least 3 ⁄
16
"
above the surface of the conveyor belt.
— if the sanding drum is not at least 3 ⁄
16
"
above the conveyor belt, repeat this proce-
dure until it is.
the setting of the elevation stop screw was cor-
rectly set at the factory. however, if it is necessary
to re-adjust the stop screw, perform this proce-
dure.
tools Needed Qty
Wrench 10mm ................................................... 1
phillips screwdriver #2 ...................................... 1