beautypg.com

Test run – Grizzly Variable Speed Wood G0632 User Manual

Page 22

background image

-20-

Model G0632 (Mfg. 4/12+)

Before starting the lathe, make sure you

have performed the preceding assembly

and adjustment instructions, and you have

read through the rest of the manual and

are familiar with the various functions and

safety features on this machine. Failure to

follow this warning could result in serious

personal injury or even death!

Test Run

Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation. The test run consists
of verifying the following: 1) The motor powers up
and runs correctly and 2) the stop button safety
feature works correctly.

If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review

Troubleshooting on Page 39.

If you cannot find a remedy, contact our Tech
Support at (570) 546-9663 for assistance.

5. Verify that the machine is operating correctly

by pressing the REV/FWD switch to FWD.

—When operating correctly, the machine

runs smoothly with little or no vibration or
rubbing noises.

— Investigate and correct strange or unusual

noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.

6. Press the REV/FWD switch to the center

neutral position to stop the machine, and
push in the EMERGENCY stop button.

7. WITHOUT resetting the EMERGENCY stop

button, press the press the REV/FWD switch
to FWD. The machine should not start.

—If the machine does not start, the

EMERGENCY stop button safety feature
is working correctly. The

Test Run is com-

plete.

—If the machine does start (with the

EMERGENCY stop button pushed in),
immediately disconnect power to the
machine. The EMERGENCY stop button
safety feature is not working correctly. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.

To test run your lathe:

1. Make sure you understand the safety instruc-

tions at the beginning of the manual and that
the machine is setup properly.

2. Make sure all tools and objects used during

setup are cleared away from the machine.

3. Connect the machine to the power source.

TWIST

Twist Button

Counterclockwise

To Reset
Switch...

Figure 18. Resetting the EMERGENCY stop

switch.

4. Push the EMERGENCY stop button in, then

twist it clockwise so it pops out. When the
button pops out, the switch is reset and ready
for operation (see

Figure 18).