FUJITSU SPARC ENTERPRISE M4000 - Manual (Page 225)

setroute(8)
System Administration 245
NAME setroute - set routing information for an XSCF network interface
SYNOPSIS setroute -c {add | del} -n address [-m address] [-g address] interface
setroute -h
DESCRIPTION setroute (8) command sets routing information for an XSCF network interface.
Up to eight routing information items can be registered for each network interface.
Any attempt to register more than eight items causes an error.
Privileges You must have platadm privilege to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-c {add|del} Specifies a function for routing information. One of the
following values can be specified. If none of them is specified, an
error occurs.
add Adds routing information.
del Deletes routing information.
-g address Specifies a gateway address used for routing. The specified
value of address is a set of four integer values delimited by the
period (.). If this option is omitted, the gateway address is not
set.The following address form is accepted:
xxx.xxx.xxx.xxx
xxx
An integer from 0–255. Zero suppression
can be used to specify the integer.