FireplaceXtrordinair Revolution 36CF - Manual (Page 21)

Installation
(for qualified installers only)
21
© Travis Industries 4090102 100-01212_000
Approved Vent Configurations
Exhaust Restrictor Adjustment
An exhaust restrictor is built into exhaust vent at the rear of the fireplace. It is used to adjust the flow rate of
exhaust gases. Depending upon vent configuration, you may be required to adjust the restrictor. The
charts for acceptable vent configurations detail the correct vent restrictor position. The restrictor is
accessed from inside the firebox (remove the glass to gain access). To adjust the restrictor, remove the
nut and bolt holding the restrictor in position, rotate the restrictor to the correct position, then replace the
nut and bolt to secure (see
Figure 11 ).
Figure 11
The fireplace ships in
restrictor position # 1.
Position # 2
Position # 3
Position # 4
Position # 5