Installation – FireplaceXtrordinair Revolution 36CF User Manual

Page 17

Installation

(for qualified installers only)

4090102

100-01212_000

Remote Synchronization

The fireplace is shipped with the remote and fireplace

pre-synchronized

. Do not

synchronize the remote unless you are 100% sure it does not work correctly.

Synchronizing the Remote

NOTE: The fireplace must have power and the transmitter must have batteries to complete this process.

WARNING: Shut the gas off to the fireplace prior to conducting this process.

Press the “Learn” button once. The fireplace will beep once.

Press the “Mode” button on the remote. The fireplace will beep five times to indicate
synchronization.

NOTE: Re-setting the Receiver Module

If the receiver module fails to synchronize with the remote after two attempts, you should re-set the
receiver module. To do this, hold down the LEARN button for approximately 10 seconds until the
receiver beeps 3 times. This indicates the receiver has been re-set and can be synchronized using
the instructions above.