Freescale Semiconductor i.MX27 PDK 1.0 - Manual (Page 23)

Freescale Semiconductor i.MX27 PDK 1.0 Hardware User's Guide, Rev. 1.0 3-5
3. Connect the regulated 5V power supply to the appropriate power adapter. Plug the power adapter
into an electrical outlet and the 5V line connector into the J2 (5V POWER JACK) connector on the
Debug board. See Figure 3-5.
4. Start a serial console application on your host PC with the following configuration:
⎯ Baud rate: 115200
⎯ Data Bits: 8
⎯ Parity: none
⎯ Stop Bits: 1
⎯ Flow Control: none
5. On the Debug board, switch the power switch (S4) to 1.
6. The OS image pre-loaded in the 3-Stack board will boot and the debug messages from the
bootloader should now appear on the serial console application on your PC
3.2 Build a Demo Platform: Assemble 2 Boards
This section explains how to make a demonstration platform using the Personality and CPU boards. To
make a demonstration platform, the CPU board is directly connected to the Personality board using the
500-pin connector; the Debug board is not used (Figure 3-5).
NOTE
If your system is already configured as a development platform (using all three
boards), disconnect all boards from each other.