Fostex LIVE RECORDING MIXER LR16 - Manual (Page 83)

83
Model LR16 [Recorder function / Other functions]
Setting FS/Bit of project
You can select the FS (sampling frequency)
and Bit length combination of a newly cre-
ated project. By default, it is set to 44 kHz/16
bits.
(1) Press the [ENTER] key to bring up the
MENU screen.
When you bring up the MENU screen for
the first time, "Mark point" is highlighted.
(2) Use the [MENU] dial to highlight "System"
and press the [ENTER] key.
The display now shows the system menu
screen.
: The FS/Bit setting here does not af-
fect to existing projects. The setting affects
to a project recorded by the new project
mode or a project newly created via the
"Project" menu of the MENU mode.
(3) While "Default FS" menu is highlighted,
press the [ENTER] key.
The current setting starts flashing (by
default, "44K/16" is selected).
(4) Use the [MENU] dial to select the desired
FS/Bit combination and press the [ENTER]
key to confirm the setting.
You can select from "44K/16" (default),
"44K/24", "48K/16" and "48K/24".
(5) Press the [STOP] key to exit the MENU
mode.
The selected FS/Bit combination is shown
on the Home screen.
: If you change the FS/Bit combi-
nation of an existing project and attempt
to make recording, the following warn-
ing message appears. Revert to the origi-
nal FS/Bit combination of the project.
: If you initialize the system
memory via the "Sys default memory"
menu item of the "System" menu, the
FS/Bit combination reverts back to the
default setting ("25FPS").