FUJITSU SRS-1050 - Manual (Page 98)

SRS -1050 Local Features ( Chapter 3
Page 3-44
If the factory-set normal speaker volume is too low for your environment, the menu mode options allow you to
increase the factory setting by two or four dB. You can also return to the normal setting.
The default volume you set in this procedure remains effective even if you remove and reconnect power. Only if
you reinitialize the phone does the default volume return to the normal setting.
To change the initial speaker volume, follow these steps:
1. Press REG (softkey 4), 13, ENTER (softkey 1). A screen appears showing the current speaker volume setting:
SPEAKER VOLUME
NORMAL
2. Press ENTER again and this menu appears:
1:NORMAL 2:VOL-UP1
3:VOL-UP2 (SELECT 1-3)
3. Press ENTER again and this menu appears:
1:NORMAL 2:VOL-UP1
3:VOL-UP2 (SELECT 1-3)