FUJITSU SRS-1050 - Manual (Page 33)

Chapter 2 ( SRS -1050 Voice Features
Page 2-5
c. Press an idle Call
Appearance button to get a
dial tone. This will either
hang up on the active call or
automatically place it on
hold, depending on your
installation. Your System
Administrator can tell you
which occurs.
2. To make your call, dial the
desired number by pressing the
keys on the numeric keypad.
3. If your call is not answered, you
can hang up as follows:
a. Replace the handset in its
cradle.
or
b. Press an idle Call
Appearance button which
will give you a dial tone.
or
c. Press DROP.
4. If your call is answered,
converse with the called party.
5. When your conversation ends,
you have these choices:
Hang up by replacing the handset
in its cradle. Note the displayed
call duration; it vanishes after
about three seconds.
If you put your original call on
hold, pick up the call by pressing
its red-flashing Call Appearance
button.
Note: You can also use a one-
touch button after handling
the active call. This
automatically dials the
number. Skip step 2.
Receiving Handset Calls
An incoming call makes the
phone ring and the Call
Appearance's LED flash green.
If you are not talking on
another call
1. Pick up the handset. If this does
not connect you with the
incoming call, press the green-
flashing Call Appearance
button.
2. Converse with the calling party.
3. When your conversation ends,
hang up by replacing the
handset in its cradle. Note the
displayed call duration; it
vanis hes after about three
seconds.