FUJITSU SRS-1050 - Manual (Page 89)

Chapter 3 ( SRS -1050 Local Features
Page 3-35
If for any reason you become confused, you can always press REG (softkey 4) to return to the menus and start
over.
Enabling the UNA Feature
To enable unanswered call logging and select the type of UNA to be used, follow these steps:
1. Press REG (softkey 4), 4, ENTER (softkey 1).
If the following screen appears, the UNA feature is disabled:
UNA SERVICE MODE
NON SUPPORTED
To leave it as is, press REG again.
2. To enable UNA, press ENTER. This screen appears:
1:ALL 2:SELECT
3:NO SUPPORT (SELECT 1-3)
To support UNA on all Call Appearances, follow these steps:
1. Press 1, ENTER, and this screen appears:
SUPPORTED (ALL)
COMPLETED
After about 15 seconds, or if you press asterisk (*), the display returns to the second menu mode screen:
4:UNA 5:H-FREE
6:HAND/HEAD (SELECT 1-14)
2. You can now select a different menu function, or press REG (softkey 4) to return to the normal display:
12:55PM WED MAY 1
. . . . . . . . . . . . . . . . . . . . . . . . . . .
To support UNA on selected Call Appearances, follow these steps:
1. Press 2, ENTER, and this screen appears:
SUPPORTED (SELECT)
SELECT ASSIGN KEY
If ALL (default) was previously set, all feature buttons light green.
Only Call Appearances with lit LEDs will log unanswered calls. Press the buttons to turn the LEDs on or off to
select the Call Appearances for which you want to log unanswered calls.
2. Press ENTER when done, and this screen appears: