FUJITSU SRS-1050 - Manual (Page 64)

SRS -1050 Local Features ( Chapter 3
Page 3-10
4. To leave menu mode and return
to normal operation, press REG
(softkey 4).
The use of one-touch buttons for
dialing is described in Chapter 2.
SETTING THE
CALENDAR/CLOCK
The normal SRS-1050 display
includes the date, time, and day of
the week. You can set the date
and time by using the procedure
described below.
Notes on Entering
Information
If the value you have entered is
acceptable, press ENTER to
record it and display the next
parameter screen.
To change a numerical entry (not
including menu selections) before
you press ENTER, press CLEAR
(softkey 3) and enter the desired
value.
To change a menu selection or a
numerical entry after you press
ENTER, press asterisk (*). This
returns you to the preceding data
entry screen, where you can enter
the correct information.
Setting Calendar and Clock
Values
To set the calendar/clock, follow
these steps:
1. Press REG (softkey 4), 2, ENTER
(softkey 1). This screen
appears:
ENTER CALENDAR/CLOCK
8:06PM SUN APR 30
2. Press ENTER. The first input
screen appears:
INPUT HOUR ->
8:06PM '93 APR 30
3. Enter the present hour using the
numeric keypad and then press
ENTER.
The screen changes to reflect
your entry and to prompt for the
minute. In this example, assume
you entered 12.
INPUT MINUTE ->
12:06PM '93 APR 30
Note: If you enter #, *, or too
large a value, such as 33, for
the hour, it is ignored, and
you must supply a valid entry.
4. Enter the present minute using
the numeric keypad and then
press ENTER (softkey 1).