Fluke 1595A - Manual (Page 38)

1594A/1595A Super-Thermometer
Main Menu
28
5.6.6 START/STOP MEASUREMENT (F1)
The Start/Stop Measurement function key is a toggling function key that starts and stops measurement
sampling.
5.6.7 SHOW TABLE/GRAPH (F2)
The Show Table/Graph function key toggles the display between Graph mode and Data mode.
5.6.8 RESET STATISTICS (F3)
The Reset Statistics function key resets all statistics fields and sample counts.
5.6.9 CLEAR GRAPH/CLEAR MESSAGE (F4)
The Clear Graph/Clear Message function key clears the measurement trend graph. When an alert message is
displayed, this function key changes to Clear Message, which may be used to clear the alert message.
5.6.10 START/STOP RECORD (F5)
The Start/Stop Record function key is a toggling function key that starts and stops recording of measurements
to memory (see Section 5.7.3.4, RECORDING MENU (F4), on page 41).
5.7 Main Menu
The Main Menu is accessed by pressing the MENU key. The Main Menu contains the submenus used for
Super-Thermometer configuration and setup.
Figure 6- Main Menu Screen
The submenus located in the Main Menu screen are as follows:
CHANNEL SETUP - for configuring measurement channels and reference resistor settings
PROBE MENU - for assigning probe definitions to measurement channels and managing the Probe Library
MEASURE MENU - for configuring channel scanning, setting measurement timing, configuring the digital
filter and turning recording on and off