FUJITSU IMAGE FI-5530C2 - Manual (Page 25)

1.2 Placing Documents on the ADF
fi-5530C2 Image Scanner Operator’s Guide
9
B
A
S
IC SCANNE
R OP
ERA
T
IONS
1
5. Adjust the side guides to the width of the document.
Move the side guides so that they touch both sides of the document.
If there is any clearance between the side guides and the edges of the document, the scanned
image may be skewed.
6. Start up the scanner application, and then scan the document.
For details on how to scan documents using the ScandAll PRO application, refer to section
1.5
"How to Use ScandAll PRO" on page 29 .
HINT
The stacker prevents document sheets from being scattered after they
were scanned.
Use the stacker as follows:
1. Lift the stacker toward you by using your fingertips and the handle on
the scanner.
2. Lift the paper stop and extend it toward you by using your fingertips
and the indentations on the stacker.
Side guides
handle
Indentation