FUJITSU Image Scanner fi-5650C - Manual (Page 26)

CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
2.1 Turning the scanner ON/OFF
2.2 Loading documents onto the ADF
2.3 Scanning documents
2.4 How to use the Scanner Driver
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
2.1 Turning the scanner ON/OFF (Continued from the previous page)
Power Save Mode
The Power Saving Mode is designed to reduce the scanner's power consumption when not in use while switched on.
The scanner will switch automatically to power saving mode at preset intervals if idle and remain in a state of low power.
Power saving mode is factory preset to automatically execute at 15 minutes intervals of idle time. Please refer to 7.9 Power saving to adjust
the preset execution time.
In the Power Save mode, the indication of the Function No. display on the operator panel goes out, while the green LED is kept lit.
To return the scanner from the Power Save mode, perform one of the following operations:
● Load documents on the ADF paper chute.
● Press any button on the operator panel.
● Execute a command from the scanner driver.
1 | 2
All Rights Reserved, Copyright (C) PFU LIMITED 2004