FUJITSU LT800P - Manual (Page 85)

83
U s i n g t h e W i r e l e s s L A N
8. When you finish your entry, click [OK]. [Wireless Network Connection 2 Proper-
ties] appears again.
9. Make sure the network name you specified for the SSID in Step 7 is added under
[Preferred networks].
Network Connection 8
The section describes how to set the network connection for a computer running
Windows XP.
Network Settings 8
In this section, you set “TCP/IP Settings,” and complete “Checking Computer Name
and Workgroup” required for the network connection.
TCP/IP Settings 8
1. On [Wireless Network Connection Properties], click [General].
2. Perform the following steps.
■ Click [Internet Protocol (TCP/IP)].
■ Click [Properties]. [Internet Protocol (TCP/IP) Properties] appears.
3. Set an IP address. Ask your network administrator and check the setting.
Table A-9 Setting an IP address
5. Click [OK].
If [Wireless Network Connection 2 Properties] is not displayed, click [Start]
-> [Settings] -> [Control Panel], and double-click the [Network
Connection] icon.
Right click the [Wireless Network Connection], and then click [Properties]
from the menu that appears.
Item Description
AdHoc Network Set the IP address and subnet mask. Click [Use the following IP
address]. Enter a value for [IP address] and [Subnet mask]. See
“Setting IP Addresses” on page 94 to set IP address and subnet
mask.
For Infrastructure
Network Select [Obtain an IP address automatically]. For the DNS server,
select [Obtain DNS server address automatically]. For the IP
address, DNS server, and default gateway, follow the network
administrator's instructions, if any.
58-0867-01.book Page 83 Thursday, February 13, 2003 1:18 PM