FUJITSU M4099D - Manual (Page 65)

5-14
■ Device and Operator Actions for Equipment Errors
If an equipment error is detected in the scanner, the (CHECK) lamp at the operator panel blinks.
Check if the lamp is attached correctly. Replace lamp
according to the replacement method. If turning the power on
again does not recover a scanner, contact a manufacturer’s
authorized service center.
If turning the power on again does not recover the scanner,
contact a manufacturer’s authorized service center.
Lamp Alarm: Front
Lamp Alarm: Back
Optical error: Front
Optical error: Back
Hopper over run
Paper feed error.
Clear paper path to continue
Hardware alarm
EEPROM alarm
Heater Alarm 1
Heater Alarm 2
Make sure that there is not anything on the hopper table or in
the transport path. If turning the power on again does not
recover a scanner, contact a manufacturer’s authorized
service center.