FUJITSU M4099D - Manual (Page 16)

1-7
Lift the pick roller unit until it is
held by the magnet catch.
The hopper table moves up to the
feed position.
Inserting Documents Manually
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Hopper table Document
(face-up)
Hopper guide Guide plate
If the scanner is in Manual Mode, set the documents as follows:
NOTE
For information on setting
Manual feed timeout, see the
Operating Instructions in the
Operator’s Guide.
Insert the documents until the
leading edge touches the guide
plate of the hopper table. Adjust
the guides to the document width.
Place documents face-up at the
center of the hopper table.
CAUTION
Be careful not to catch your fingers or
something in the mechanism, when the
hopper table moves up.