Transport path, discharge brush, and glass surface, Cleaning the transport path, Cleaning the discharge brush – FUJITSU M4099D User Manual

Page 23

2-6

WARNING

Wait at least 3 minutes after turning off the power before cleaning.

ACHTUNG

Warten Sie nach dem Reinigen mindestens 3 Minuten bevor Sie den
Scanner wieder anschalten.

■

Cleaning the Transport Path

Wipe the transport path with a dry
cloth or soaked in isopropyl
alcohol or cleaner F1.

Open the upper transport unit.

Transport Path,
Discharge Brush,
and Glass Surface

NOTE

Use a vacuum cleaner to remove paper dust
from the transport path.

■

Cleaning the Discharge Brush

Open the upper transport unit.

Release the ADF release lever
and rest the ADF sheet guide
assembly on the ADF release
lever.

While pulling the ADF release
lever toward you, hold up the ADF
sheet guide assembly.

CAUTION

Never close the upper transport unit in this
condition. Doing so will cause severe
damage to the scanner.

Pick roller unit

ADF release levers