beautypg.com

4 setting the scsi id, 5 installing the drivers and software – FUJITSU M3091DC User Manual

Page 27

background image

2.3.4 Setting the SCSI ID

This section explains how to set the SCSI ID.

1) Disconnect the power cable from the outlet.

2) Set the device address using the SCSIID switch on the rear of the scanner.

Precautions for setting the device address

Address No.

Description

0 - 7

Can be set

8, 9

If 8 or 9 is set, factory setting (SCSI ID = 5) is used.

3) After setting the SCSI ID number, insert the power cable into the outlet.

2.3.5 Installing the drivers and software

Execute Setup.exe on the supplied setup disks (driver disk 1 and software disk 1) to install the

software and drivers. To use the scanner's operator panel, all software disks must be installed.

C Note
Read Readme.txt on the floppy disk before installing the software.

See also other documents in the category FUJITSU Scanners: