Fluke 1529 Chub-E4 - Manual (Page 114)

8.4.7.8 LOGging:AUTomatic:PRINt [|ALL [,]]
Prints the auto log entries.
LOG:AUT:PRIN ALL
DATA_25 1 22.676C 12:19:42 09-05-00
DATA_25 2 9.960 KO 12:19:44 09-05-00
DATA_25 3 23.220C 12:19:46 09-05-00
DATA_25 4 23.245C 12:19:48 09-05-00
DATA_25 1 22.765C 12:19:52 09-05-00
DATA_25 2 9.962 KO 12:19:54 09-05-00
DATA_25 3 23.087C 12:19:56 09-05-00
DATA_25 4 23.260C 12:19:58 09-05-00...
If no parameters are specified, the ALL parameter is assumed and all auto log
entries are printed to the serial port. Specifying the parameter prints
only the log entries with the specified label number to the serial port. Op-
tionally, the log entries may be printed to a specific port by specifying the
parameter (see Table 10 on page 129, Port Numbers).
8.4.7.9 LOGging:AUTomatic:STATus?
Returns the auto log status.
LOG:AUT:STAT?
0
If this query returns a 0, an auto log session is not running. If this query returns
a 1, an auto log session is running.
8.4.7.10 LOGging:AUTomatic:STATus
Sets the auto log status.
LOG:AUT:STAT 0
The parameter turns auto logging on (1 or ON) or off (0 or OFF). If si-
multaneous scan mode is enabled, one measurement is stored for each channel
in the auto log. The *RST command set the auto log status to off.
8.4.7.11 LOGging:AUTomatic:TIMe? [MIN|MAX|DEF]
Returns the auto log interval setting.
LOG:AUT:TIM?
1
Specifying the MIN parameter returns a value of 0.1. Specifying the MAX pa-
rameter value returns value of 3600. Specifying the DEF parameter returns a
value of 1. The units are seconds.
1529 Chub-E4 Thermometer Readout
User’s Guide
108