Fluke 1529 Chub-E4 - Manual (Page 101)

8.4.3.6 ROUTe:SCAN?
Returns a comma delimited list of the enabled channels.
ROUT:SCAN?
(@2,3,4)
The list of channels is enclosed in parenthesis and preceded with the @
symbol.
8.4.3.7 ROUTe:SCAN
Sets the channels for scanning.
ROUT:SCAN 2,3
The parameter is a comma delimited list of the channels (1 to 4) to
enable. Channels that are omitted from this list are disabled. If the
parameter is omitted, all channels are disabled. The *RST command sets chan-
nel 1 ON, and all other channels OFF.
8.4.3.8 ROUTe:SCAN:MODE? [MIN|MAX|DEF]
Returns the current scan mode setting.
ROUT:SCAN:MODE? MIN
0
If 0 is returned, the scan mode is simultaneous. If a 1 is returned the scan mode
is scan. Specifying the MIN parameter returns a value of 0. Specifying the
MAX parameter returns a value of 1. Specifying the DEF parameter returns a
value of 1.
8.4.3.9 ROUTe:SCAN:MODE |MIN|MAX|DEF
Sets the scan mode setting.
ROUT:SCAN:MODE 1
The specifies the scan mode (1 for scan, 0 for simultaneous). Spec-
ifying the MIN, MAX, or DEF parameter sets the mode to the minimum, maxi-
mum, or default, respectively. The *RST command sets scan mode to scan.
8.4.4 Probe Commands
The probe commands are used for querying, setting, and copying the probe
conversion type, conversion parameters, and serial number and for testing the
temperature conversion for a channel. The probe commands for copying and
setting parameters are password protected.
8.4.4.1 CALCulate:CONVert:CATalog?
Returns a list of conversion types available for the specified channel.
95
8 Digital Communications Interface
Commands