Fluke 1529 Chub-E4 - Manual (Page 108)

Thermistors (2). For Thermocouple channels, the calibration scale suffix is
ignored and may be omitted. Note: For PRT/Thermistor channels, the value re-
turned by this command is always in ohms.
For PRT/Thermistor channels, specifying the MIN parameter returns a value of
-9 when the scale suffix is 1 (for PRTs) and -9000 when the scale suffix
is 2 (for Thermistors). For Thermocouple channels, specifying the MIN
parameter returns a value of -9. For PRT/Thermistor channels, specifying the
MAX parameter returns a value of 9 when the scale suffix is 1 (for PRTs)
and 9000 when the scale suffix is 2 (for Thermistors). For Thermocouple
channels, specifying the MAX parameter returns a value of 9. Specifying the
DEF parameter returns a value of 0.
8.4.5.9 CALibrate:PARameter:SCALe |MIN|MAX|DEF
Sets the calibration scale parameter for the specified channel.
CAL1:PAR:SCAL2 2
The CALibrate suffix, , specifies the channel (1 to 4). This command
does not apply to memory channels. For PRT/Thermistor channels, the calibra-
tion scale suffix specifies the resistance range parameter (in ohms) for
PRTs (1) or Thermistors (2). For Thermocouple channels, the calibration scale
suffix is ignored and may be omitted. The parameter specifies the
value for the specified scale parameter. Specifying the MIN, MAX, or DEF pa-
rameter sets the scale parameter to the minimum, maximum, or default value
respectively.
This command is password-protected. To access this command, the password
must be successfully entered using the SYST:PASS:CEN command
(see Section 9.4.11, Password Commands).
8.4.5.10 CALibrate:PARameter:LINearity? [MIN|MAX|DEF]
Returns the calibration linearity parameter for the specified channel.
CAL1:PAR:LIN1?
2.8
This command only applies to PRT/Thermistor channels. Executing this com-
mand on Thermocouple channels generates a -294, "Incompatible type" error
message.
The CALibrate suffix, , specifies the channel (1 to 4). This command
does not apply to memory channels. For PRT/Thermistor channels, the calibra-
tion linearity suffix, , specifies the resistance range parameter for PRTs (1)
or Thermistors (2). Note: For PRT/Thermistor channels, the value returned by
this command is always in ohms.
Specifying the MIN parameter returns a value of -9 when the linearity suffix
is 1 (for PRTs) and -9000 when the linearity suffix is 2 (for Thermis-
tors). Specifying the MAX parameter returns a value of 9 when the linearity
1529 Chub-E4 Thermometer Readout
User’s Guide
102