Fluke 1529 Chub-E4 - Manual (Page 100)

8.4.3 Channel Commands
The channel commands are used for querying and setting the current channel,
the channels to scan, the type of scanning, and the state of the channel scan-
ning. The channel commands are not password protected.
8.4.3.1 ROUTe:CLOSe?
Returns the state of the specified channel.
ROUT:CLOS? 1
0
The parameter specifies the channel (1 to 4). If the specified channel is
enabled, this query returns 1. If the specified channel is disabled, this query re-
turns 0.
8.4.3.2 ROUTe:CLOSe
Enables the specified channel.
ROUT:CLOS 3
The parameter specifies the channel (1 to 4) to enable. This comand
does not apply to memory channels.
8.4.3.3 ROUTe:OPEN?
Returns the state of the specified channel.
Example: ROUT:OPEN? 1
Response: 0
The parameter specifies the channel (1 to 4). If the specified channel is
enabled this query returns 0. If the specified channel is disabled, this query re-
turns 1.
8.4.3.4 ROUTe:OPEN
Disables the specified channel.
Example: ROUT:OPEN 4
The parameter specifies the channel (1 to 4) to disable. This command
does not apply to memory channels.
8.4.3.5 ROUTe:PRIMary?
This query command returns the number of the primary channel.
Example: ROUT:PRIM?
Response: 1
1529 Chub-E4 Thermometer Readout
User’s Guide
94