Fluke 1529 Chub-E4 - Manual (Page 103)

type. The acceptable conversion types depend on the channel type. The conver-
sion types and their names are listed in Table 7 on page 128.
This command may be password-protected. To access this command:
• If the SYST:PASS:CONV? command returns a 0 (probe password-protec-
tion is disabled), the password is not required.
• If the SYST:PASS:CONV? command returns a 1 (probe password-protec-
tion is enabled), the password must be successfully entered using the
SYST:PASS:CEN command (see Section 9.4.11, Password Com-
mands).
8.4.4.5 CALCulate:CONVert:PARameter:CATalog?
Returns the names of the probe characterization parameters associated with the
current conversion type for the specified channel.
CALC2:CONV:PAR:CAT?
“RANGE”,”RTPW”,”A4”,”B4”,”A”,”B”,”C”,”D”
The CALCulate suffix, , specifies the channel (1 to 4) or memory chan-
nel (5 to 14). Each item in the response list is enclosed in double-quotes and
separated from other items by a comma. Each item indicates the name of a
characterization parameter for the current conversion type.If there are no pa-
rameters available for the current conversion type, an empty string is returned.
The list of parameters depends on the selected conversion type. Characteriza-
tion parameters for the various conversion types are listed in Table 8 on page
128, Conversion Types and Parameters.
8.4.4.6 CALCulate:CONVert:PARameter:VALue? [|ALL]
Returns the value of the specified conversion parameter for the specified
channel.
CALC2:CONV:PAR:VAL? RTPW
100.0145
The CALCulate suffix, , specifies the channel (1 to 4) or memory chan-
nel (5 to 14). The parameter is the name of the parameter as given in
Table 8, Conversion Types and Parameters. If the parameter does not
apply to the selected conversion type, an error -221, “Settings Conflict”, is
generated. Specifying the ALL parameter returns the name and value of all pa-
rameters associated with the specified channel in a comma delimited list. If no
parameter is specified, the ALL parameter is assumed. The format of the re-
sponse consists of a parameter name, enclosed in double quotes, followed by its
value (i.e. "param1",value1,"param2",value2,"param3",value3,...).
8.4.4.7 CALCulate:CONVert:PARameter:VALue ,[,<
param>,...]
Sets the value of one or more conversion parameters for the specified channel.
97
8 Digital Communications Interface
Commands