Fluke 1529 Chub-E4 - Manual (Page 105)

can consist of up to eight characters that include any letters, numeric digits, and
the underscore ‘_’.
This command may be password-protected. To access this command:
• If the SYST:PASS:CONV? command returns a 0 (probe password-protec-
tion is disabled), the password is not required.
• If the SYST:PASS:CONV? command returns a 1 (probe password-protec-
tion is enabled), the password must be successfully entered using the
SYST:PASS:CEN command (see Section 9.4.11, Password Com-
mands).
8.4.4.11 CALCulate:CONVert:TEST? |
Tests the temperature conversion for the specified channel.
CALC2:CONV:TEST? 100.0145
0.0100
The CALCulate suffix, , specifies the channel (1 to 4) or memory chan-
nel (5 to 14). For PRT/Thermistor channels, the parameter specifies a re-
sistance value to convert to temperature. The parameter is always in
Ohms for PRTs and KOhms for Thermistors. For Thermocouple channels, the
parameter specifies a voltage value to convert to temperature. The
parameter is always in mV. The response to this command is a tempera-
ture in the currently selected units. The current system units determine the scale
of the response.
8.4.5 Calibration Coefficient Commands
The calibration coefficient commands are used for querying and setting the
channel calibration date, due date, linearity, offset, scale, and RJC.
8.4.5.1 CALibrate:AUTo
Executes the automatic calibration procedure when using Fast Measurement
Mode (see Sections 6.9, Fast Measurement Mode, 7.1.1, Measure Period and
Fast Measurement Mode, and 7.1.5, Display Functions/Auto-Cal).
CAL:AUT
8.4.5.2 CALibrate:DATE:CALibrate? [MIN|MAX|DEF]
Returns the calibration date for the specified channel.
CAL1:DATE:CAL?
2000,9,22
The CALibrate suffix, , specifies the channel (1 to 4). This command
does not apply to memory channels. The response is returned in the format,
,,. Specifying the MIN parameter returns a value of
99
8 Digital Communications Interface
Commands