FUJITSU MCJ3230AP - Manual (Page 146)

Host Interface
4-74 C156-E205-01EN
4.6.22 VERIFY command
Table 4.112 VERIFY command
Bit
Byte
7 6 5 4 3 2 1 0
0 Operation Code (2Fh)
1 Reserved ByteChk Reserved
2-5 Logical Block Address
6 Reserved
7-8 Verification Length
9-11 Reserved
The VERIFY command verifies for the specified number of blocks from the
specified logical block address.
Logical Block Address specifies the head logical block address from which
verification starts.
Verification Length specifies the number of blocks to be verified and transferred.
When Verification Length is 0, the command verifies no block and ends normally.
The ByteChk bit indicates data compare execution. However, since the ByteChk
is not supported, it must be set to 0. If a value 1 is specified, the command ends
with Check Condition.
4.6.23 WRITE (10) command
Table 4.113 WRITE (10) command
Bit
Byte
7 6 5 4 3 2 1 0
0 Operation Code (2Ah)
1 Reserved
2-5 Logical Block Address
6 Reserved
7-8 Transfer Length
9-11 Reserved