FUJITSU DESKPOWER 2000 - Manual (Page 43)

31
Min. Power Saving Minimum power management.
Suspend Mode = 1hr., and HDD Power Down = 15
min.
Max. Power Saving Maximum power management — Suspend
Mode = 1 min., and HDD Power Down = 1 min.
User Defined (default) Allows you to set each mode individually. When not
disabled, each of the ranges are from 1 min. to 1
hr. except for HDD Power Down which ranges from
1 min. to 15 min. and disable.
• Video Off Method
This determines the manner in which the monitor is blanked.
• Video Off In Suspend
This determines the manner in which the monitor is blanked.
The settings are: Yes and No.
• Suspend Type
Select the Suspend Type. The settings are: PWRON Suspend, Stop Grant.
• Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
• Suspend Mode
When enabled and after the set time of system inactivity, all devices except the
CPU will be shut off. The settings are: 1/2/4/8/12/20/30/40 Min, 1 Hour,
and Disabled.
• HDD Power Down
When enabled and after the set time of system inactivity, the hard disk drive
will be powered down while all other devices remain active.
The settings are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15Min and Disabled.
• Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter
the Soft-Off state. The settings are: Delay 4 Sec, Instant-Off.
V/H SYNC+Blank This selection will cause the system to turn off the
ver tical and horizontal synchronization por ts and
write blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS (default) Initial display power management signaling.
She_Chp2_14-38 11/3/00, 11:05 31