FUJITSU DESKPOWER 2000 - Manual (Page 34)

22
• Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When
enabled, the typematic rate and typematic delay can be selected.
The settings are: Enabled/Disabled.
• Typematic Rate (Chars/Sec)
Sets the number of times a second to repeat a key stroke when you hold the
key down. The settings are: 6, 8, 10, 12, 15, 20, 24, 30.
• Typematic Delay (Msec)
Sets the delay time after the key is held down before it begins to repeat the
keystroke. The settings are: 250, 500, 750, 1000.
• Security Option
This categor y allows you to limit access to the system and Setup, or just to
Setup.
System The system will not boot and access to Setup will be
denied if the correct password is not entered at the
prompt.
Setup(default) The system will boot, but access to Setup will be
denied if the correct password is not entered at the
prompt.
• OS Selection for DRAM > 64MB
Allows OS2 ® to be used with > 64 MB of DRAM. Settings are Non-OS/2
(default) and OS2. Set to OS/2 if using more than 64MB and running OS/2 ® .
• HDD S.M.A.R.T. Capabilty
When Enabled is selected, waring is displayed immediately before HDD is
broken.
The settings are: Enabled and Disabled.
• Report No FDD For Win 95
Whether repor t no FDD for Win 95 or not. The settings are: Yes, No.
• Full Screen LOGO Show
When Enabled is selected, the LOGO is displayed at Boot.
The settings are: Enabled and Disabled.
• Gate A20 Option
Normal The A20 signal is controlled by keyboard controller or
chipset hardware.
Fast(default) The A20 signal is controlled by port 92 or chipset
specific method.
She_Chp2_14-38 11/3/00, 11:05 22