HP DL785 - Manual (Page 30)

1. Power down the server ( “Power down the server” (page 25) ).
2. Press the release button.
3. Open the lever.
4. Grasp the lever and slide the processor memory cell from the enclosure. Place a hand under
the component to support it as you remove it from the enclosure.
CAUTION: Always place the processor memory cell on a flat, level, antistatic surface when
working with the component.
To replace the processor memory cell reverse the procedure.
Processor memory cell bezel
To remove the processor memory cell bezel:
1.
Power down the server ( “Power down the server” (page 25) ).
2. Pull out the processor memory cell enough to access the bezel ( “Processor memory cell”
(page 29) ).
3. Press the back of the bezel, slide it upward, and remove the component.
To replace the component, reverse the removal procedure.
Processor memory cell airflow baffle
To remove the processor memory cell airflow baffle:
1.
Power down the server ( “Power down the server” (page 25) ).
2. Remove the processor memory cell ( “Processor memory cell” (page 29) ).
3. Press the two airflow baffle release tabs, pivot the airflow baffle up, and remove the
component.
To replace the component, reverse the removal procedure.
Processors
The server supports a four- or eight-processor configuration.
30 Removal and replacement procedures