HP DL785 - Manual (Page 29)

NOTE: The release latch does not need to be pressed to reinsert the media module.
Front Bezel
To remove the front bezel:
1.
Power down the server ( “Power down the server” (page 25) ).
2. Extend or remove the server from the rack ( “Extending the server from the rack” (page 25)
or “Removing the server from the rack” (page 26) ).
3. Remove processor memory cell 1 ( “Processor memory cell” (page 29) ).
4. Remove the serial number tag.
5. Remove the eight screws (four on each side) that secure the bezel to the server.
6. Hold the top two corners of the bezel and pull the bezel away from the server until the two
soft release tabs under the hard drive cage release.
7. Hold open the release latches at the bottom corners of the bezel.
8. Slide the bezel to the right to release it from the tabs on the bottom corners of the chassis
and pull it away from the server.
Reverse the procedure to replace the front bezel.
Mezzanine filler
To remove the mezzanine filler:
1.
Power down the server ( “Power down the server” (page 25) ).
2. Press the release button.
3. Open the lever.
4. Grasp the lever and slide the mezzanine filler from the enclosure. Place a hand under the
component to support it as you remove it from the enclosure.
To replace the mezzanine filler reverse the procedure.
IMPORTANT: If replacing the mezzanine filler with a new mezzanine filler, the mezzanine
board must be moved to the new mezzanine filler (see “Mezzanine board” (page 29) ).
Mezzanine filler bezel
To remove the mezzanine filler bezel:
1.
Power down the server ( “Power down the server” (page 25) ).
2. Pull out the mezzanine filler enough to access the bezel ( “Mezzanine filler” (page 29) ).
3. Press the two release tabs and remove the component.
To replace the mezzanine filler bezel reverse the procedure.
Mezzanine board
To remove the mezzanine board:
1.
Power down the server ( “Power down the server” (page 25) ).
2. Remove the mezzanine filler ( “Mezzanine filler” (page 29) ).
3. Use a T-15 Torx screwdriver to remove the six screws holding the mezzanine board to the
mezzanine filler.
To replace the mezzanine board reverse the procedure.
Processor memory cell
To remove the processor memory cell:
Front Bezel 29