HP zl - Manual (Page 44)

hp toptools for openview nnm user guide
Page 44 Version 5.6
Figure 5-7. HP Vectra Property Pages are similar to Kayak and Omnibook pages.
The information displayed is obtained from two locations: a small amount of information is pulled from the
discovery database on the toptools server, and the remainder is obtained from direct requests to the system itself.
The Identity page displays the word “Connected” or “Not Connected” above the photograph of the system to
indicate whether or not the toptools server can directly connect to the system. If the toptools server cannot connect
to the system, only the information from the toptools server discovery database is used to generate the Property
pages. In this case, the Property pages will consist of the Identity page and Status page.
Note: The Properties menu item is only available for one system at a time. If there is more than one
system in the NNM selection list, the Properties item will not be enabled (Figure 5-8).
Figure 5-8. Toptools actions can be applied to more than one HP PC.