HP zl - Manual (Page 17)

hp toptools for openview nnm user guide
At this point, setup displays the port number on which it intends to service requests. The default is 5041. If for
some reason, this TCP port is not available on your system, select an available port, and specify it here. A list of
reserved TCP ports is available in the \winnt\system32\drivers\etc\services file. Note that these are not necessarily
used, but that they are specified for use by certain applications. You can see a list of actively used ports by using
‘netstat –p tcp’. Regardless of which free TCP port you select, make a note of it, as you will need to indicate that
port in the second part of this installation.
Figure 2-4. TCP port 5041 is the default used by Toptools for OpenView NNM.
You will then be asked to enter the community string and IP address of the NNM system.
Page 17