HP zl - Manual (Page 26)

hp toptools for openview nnm user guide
Page 26 Version 5.6
Figure 3-3. The TCP port number must be the same port number entered for the Server Bridge.
After entering the toptools server information, the installation program continues installing and displays windows
showing the progress of the installation.
MIBs for HP Netservers, HP hubs, and HP switches will be compiled. This takes approximately 10 minutes. Some
warnings may be displayed in the HP OpenView console if the MIBs have previously been installed. (These
warnings may indicate that the “–replace” option would force installation of the MIBs. If these MIBs are already
installed, the appropriate behavior for the installation is to NOT reinstall them, so the messages can be ignored.)
Figure 3-4. SNMP MIBs for HP devices will be compiled into NNM during the installation.
By installing these MIBs, the HP OpenView NNM MIB browser can now permit you to closely examine and modify
SNMP variables for HP devices. A list of MIBs installed is given at the end of this manual.
When the installation completes, the NNM Console output will be displayed, showing you the status of the NNM
integration. The console will display information about each step of the installation. When this console display
indicates that the integration is complete, close the console output window.