Silvercrest SKM 500 B1 - Manual (Page 24)

21 SKM 500 B1
GB
4) Slide the cutting knife t with the knife guard d fi tted and the kneading
knife r over the drive shaft i onto the emulsifying disc 4.
5) Place the drive shaft adapter z and 2 disks (e.g. cutting w and shredding
disk 0) at the side next to the drive shaft i in the mixing bowl u.
6) Place the disk adapter e with the disk fi tted onto the drive shaft i.
7) Close the lid 3 and slide the pusher 1 into the fi lling shaft 2.
Fault rectifi cation
DEFECT CAUSE SOLUTION
The appliance
does not work.
The plug is not
connected. Insert the plug into a mains
power socket.
The appliance is not
correctly assembled
and engaged. Check the assembly of the
appliance and ensure that all
marks are correctly aligned.
The appliance is
defective. In this case, contact the
Customer Services.
The appliance
stops suddenly.
The lid 3 of the
appliance may have
become loose when
processing hard
ingredients.
Replace the lid 3.
The appliance is
defective. In this case, contact the
Customer Services.
The motor runs, but
the accessory parts
do not rotate.
The drive shaft i is
not inserted properly. Check the assembly of the
drive shaft i.
IB_103418_SKM500B1_LB4.indb 21 17.10.14 14:37