Quintum Technologies Tenor AX - Manual (Page 45)

3-10 P/N 480-0062-00-10
Chapter 3: Installation/Basic Troubleshooting
Connect to PC Console
You will need to connect the Tenor AX to your workstation’s serial port via RS-232 connection.
(This connection will be used when you assign an IP address to the unit.) For the instructions below,
it is assumed you are connecting to a Windows PC.
Figure 2-8 Connect to PC Com Port
1. Insert the male end of the DB-9 cable into the port labeled Console. (See Chapter 2: Hardware Compo-
nents for RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your workstation’s serial console port (see your PC documen-
tation for more information about this port).
DB-9