Quintum Technologies Tenor AX - Manual (Page 44)

P/N 480-0062-00-10 3-9
Chapter 3: Installation/Basic Troubleshooting
Connect to Ethernet LAN
You can use these instructions for general connection purposes only. The Ethernet hub/switch manu-
facturer’s documentation should provide specific instructions for connection to another device, such
as the Tenor AX.
Figure 2-7 Connect to Ethernet Hub/Switch
1. Plug one end RJ-45 Ethernet cable into the port labeled LAN.
2. Plug the other end of the cable into one of the Ethernet hub/switch ports. If a custom cable or adapter is
required, see Chapter 2: Hardware Components for Ethernet RJ-45 10/100.
Data
Network
Ethernet Hub/Switch
RJ-45 Cable