Brother FAX-220 - Manual (Page 54)

44
ADVANCED OPERATIONS
I. TEMPORARY REGISTRATION SETTINGS
While you may be satisfied with the programmed settings of the unit for virtually all of your
operations, there may be instances when you wish to change one or more of the settings. For
example, normally, you use STANDARD RESOLUTION. However, you have to transmit a
photograph. Since this is likely to be a rather infrequent type of transmission, you might wish
to change it for the duration of this one transmission only. This is accomplished via
temporary
settings. After the completion of the transmission, the unit automatically reverts to your
permanent settings (either the ones you've programmed or the factory settings if you left those).
R E M I N D E R : You can set the RESOLUTION and CONTRAST in two ways -- Temporary
or Permanent (See p.24 ~ 25). The difference when setting is whether
you put a document in the feeder (temporary) or not (permanent). The
Temporary Registration Settings are valid only for as long as the docu­
ment for which they were set is being transmitted. Once the transmission
has been compieted, the settings will revert to the User Switch Settings
or to the factory settings (if you did not program your own).
A Making Temporary Settings
1
. Set a document into the feeder. If you do not do so, you will NOT be able to
access the menu for making temporary settings. Instead, you will get the normal
FUNCTION MODE menu which you've used while getting ready to program the
unit. With the document in the feeder, the LCD will display:
^ MSG CTR
FAX/COPY READY
2
.
3.
— AUTO ANS
"^PASSWORD
Press FUNCTION. The LCD will display:
— MSG CTR
FUNCTION(0-9)? — AUTO ANS
''-PASSWORD
Now, you have a choice as to which setting you wish to change for this
transmission oniy.
Number to press
1
2
3
4
5
6
7
8
9
0
What will this do for this transmission only
Lets you change the resolution : STD, FINE, PHOTO
Lets you change the contrast : NORMAL, LIGHT, DARK
Delayed transmission
Polling (called side)
NOT USED
ON/OFF toggle switch for total number of pages sent
NOT USED
ON/OFF toggle switch for COVERPAGE™ function
ON/OFF toggle switch for call pickup alert
ON/OFF toggle switch for callback message
In virtually all of these cases, the actual procedures for altering settings are identical to the ones
described for making permanent settings (see PROGRAMMING THE UNIT). The new settings,
e.g., COVERPAGE™ function. Call Pickup Alert and CALLBACK message are explained below.