Baseline Systems FreeWave Ethernet Radio - Manual (Page 49)

User Manual and Reference Guide
LUM0024AB Rev A
NTP Client Enable
Web Parameter Enable check box in the NTP Client section of the IP Setup page.
Network Type: Both
Default Setting: Disabled
Options: Disabled, Enabled
Description: Enables the Network Time Protocol (NTP) client on the transceiver. The
transceiver checks with the NTP Server specified in the NTP Client IP
Address parameter and sets its internal clock to the time and date specified
by the NTP server.
The transceiver only checks with the NTP server on its initial startup.
Note: Test the connectivity to the NTP server and its response to NTP
requests. If the transceiver is unsuccessful connecting to the NTP server
upon booting, it makes a new request to the server before every log file entry,
which can cause unnecessary network traffic.
NTP IP Address
Web Parameter IP Address in the NTP Client section of the IP Setup page.
Network Type: Both
Default Setting: Blank
Options: Any valid IP address.
Description: The IP address of the NTP server. If the NTP Client is enabled, the
transceiver checks with this IP address upon startup to set its internal clock.
Push to Syslog Server
Web Parameter: Push to Server in the Syslog Server section of the IP Setup page.
Network Type: Both
Default Setting: Disabled
Options: Disabled, Enabled
Description: Enabling this option instructs the transceiver to send its log entries to the
system logging server identified in the Syslog Server 1 and Syslog Server 2
parameters.
Spanning Tree
Web Parameter Spanning Tree Enable check box in the LAN Network Interface
Configuration section of the IP Setup page.
33