Baseline Systems FreeWave Ethernet Radio - Manual (Page 108)

FGR2-PE Wirelss Data Transceiver
LUM0024AB Rev A
The example below shows a configuration where a Gateway routinely calls a number of Endpoints at different
times. The Gateway is communicating with a transceiver designated as an Endpoint/Repeater that is
connected to a remote device. Since this device is placed in an elevated location, the transceiver may also be
used as a Repeater when it is not used as an Endpoint. At any time the Gateway may call any of the
Endpoints, establish a connection, and send and receive data.
The next example illustrates a standard Point-to-MultiPoint network. From the Gateway, any data is
broadcast to all three Endpoints, one of which receives it through a MultiPoint Repeater. The data is in turn
sent out of the serial port of each of the three Endpoints. The end device should be configured to interpret the
serial message and act on it, if necessary.
92