Baseline Systems FreeWave Ethernet Radio User Manual
Page 157
TCP Server Port
UDP Des. IP & Port
UDP Local IP Port
UDP Power Up IP
UDP Power Up Port
UDP/Multicast Enable
Utilize For Alarm
Shared Secret, defined
Signal Alarm Below, defined
Signal Alarm Enable, defined
Signal, defined
Site Contact, defined
site information, providing
Site Name, defined
Slave Attempts, defined
Slave Connect Odds, defined
SNMP parameters
Auth Method
Auth Password (v3)
Delta Alarm Below
Delta Alarm Enable
Min Fault Time
Noise Alarm Above
Noise Alarm Enable
Privacy Method
Privacy Password (v3)
Read Community
Rx Rate Alarm Below
Rx Rate Alarm Enable
Signal Alarm Below
Signal Alarm Enable
SNMP Version
Trap Community
Trap Manager
Trap Version
Tx Rate Alarm Below
Tx Rate Alarm Enable
Voltage Alarm Above
Voltage Alarm Below
Voltage Alarm Enable
VSWR Alarm Above
VSWR Alarm Enable
Write Community
SNMP Version, defined
Software Boot Version, defined
Spanning Tree, defined
specifications
statistics
per frequency
refreshing
resetting to zero
serial port
viewing
Status parameters
Bad Packets
Broadcast Packets
Connected To
Disconnect Count
Distance
Ethernet (Rx and Tx)
Firmware Version
Hardware Version
Noise
Notes
Packets Dropped
Packets Sent
Peer-to-Peer Packets
Radio Addressed Packets
Radio Parse Error
Received
Reflected Power
RX Success Rate
RX Throughput
Serial (Rx and Tx)
Signal
Site Contact
Site Name
Software Boot Version
Status (terminal server)
System Name
User Manual and Reference Guide
LUM0024AB Rev A
141