Baseline Systems FreeWave Ethernet Radio - Manual (Page 103)

User Manual and Reference Guide
LUM0024AB Rev A
dBm or more. Noise levels significantly higher than this are an indication of a high level of interference that
may degrade the performance of the link. High noise levels can often be mitigated with band pass filters,
antenna placement, or antenna polarization.
Notes
Any additional information provided about the transceiver as defined in the Notes parameter on the Tools tab.
For more information, see "Providing Site Information" on page 20.
Packets Dropped
The number of Ethernet packets the transceiver has thrown away due to its data buffer being full.
Packets Sent
The number of Ethernet packets and bytes of data the transceiver has sent over its radio link.
Peer to Peer Packets
Note: This statistic is only valid in a MultiPoint Gateway.
The number of packets the Gateway has received from the radio link and re-transmitted out, as the destination
address was determined to be across the radio link.
Radio Addressed Packets
The number of packets sent over the transceiver where another transceiver in the wireless network was the
packet destination.
Radio Parse Error
The number or errors in data transmission between the Ethernet stack and the transceiver interface.
Received
The number of Ethernet packets and bytes of data the transceiver has received over its radio link.
Reflected Power
A measurement of the transmitted power that is reflected back into the transceiver from mismatched
antennas, mismatched cables, or loose connections between the transceiver and the antenna.
A reading of 0 to 5 is good; 5 to 29 is acceptable to marginal; 30+ is unacceptable and indicates that the
connections should be inspected for loose connections and cable quality.
RX Success Rate
Note: This statistic is only valid in a MultiPoint network.
The percentage of packets successfully received by this transceiver. This statistic displays 0.00% in a
MultiPoint Gateway. FreeWave recommends a minimum 75% success rate or proper transceiver operation.
RX Throughput
The throughput of data being received over the radio link within the last 1 second.
87