Iomega FotoShow Digital Image Center - Manual (Page 11)

Connecting Your FotoShow ™ Image Center 11
Some TVs do not have either RCA or S-Video connectors. You will need an RF modulator
(not included with your FotoShow
™ Image Center) to connect to some TVs. In many cases
you can use your VCR instead of an RF modulator. Please check Iomega’s web site at
http://www.iomegadirect.com
for recommendations on purchasing an RF modulator.
Follow the instructions included with the RF modulator to connect your FotoShow ™ Image
Center to your TV.
NOTE: Connecting the FotoShow™ Image Center will be similar to the RCA connector
instructions above, except the connections are to the RF modulator instead of the TV. Set
your TV to the channel that you set on the RF modulator (usually 3 or 4).
Using an S-Video Connector
1.Connect the S-Video cable to the S-VIDEO IN connector on the back of your TV,
VCR, AV receiver.
2.Connect the S-Video cable to the S-VIDEO OUT connector on the back of your
FotoShow ™ Image Center.
3.Connect the RCA audio connector to the AUDIO IN connector on the back of your
TV, VCR, AV receiver, or stereo system.
Make sure you match the white cable connector with the white (left, mono) AUDIO
IN
connector on the back of your TV, VCR, AV receiver, or stereo system. If the
device you are connecting to has stereo sound you will also find a red (right)
AUDIO IN
connector. The red connector is optional.
TELEVISION BACK
AUDIO/VIDEO
IN OUT
VIDEO
LEFT
AUDIO
RIGHT
AUDIO
S
VIDEO
VHF/UHF
S-VIDEO V L R