IronPort Systems ES-1528 - Manual (Page 78)

Chapter 11 QoS
ES-1528 User’s Guide
78
Figure 41 IP Address Based QoS
The following table describes the labels in this screen.
Table 21 IP Address Based QoS
LABEL DESCRIPTION
Mode Select IP Address Based QoS to give higher or lower priority to packets coming into the
switch from a specified source IP address.
Add Entry Enter the IP address and the subnet mask of the source whose traffic you want to assign
a priority to in the IP and MASK fields respectively. Select the Priority value and click
Add.
Change
Priority
Use these fields to edit existing IP address based QoS entries. Select the index of an
existing IP address based QoS entry. (This is the same value as listed in the ID column
of this screen.) Select the Priority you want to assign to this entry. Click Change to view
your changed settings.
Note: The changes are not applied until you click Apply Change
Settings.
ID, IP,
MASK,
Priority,
Delete
This is a summary table of your IP address based QoS settings. This table updates when
you click the Change button in this screen. Click DELETE in the Delete column to
remove this IP address based QoS entry from the switch.
Apply
Change
Settings
Click this when you have reviewed the changes you want to make and you want to save
them to the switch’s memory.