IronPort Systems ES-1528 - Manual (Page 64)

Chapter 8 VLAN
ES-1528 User’s Guide
64
8.2 Static VLAN
Use a IEEE 802.1Q VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
You can also tag all outgoing frames (that were previously untagged) from a port with the
specified VID.
8.2.1 IEEE 802.1Q VLAN Screen
See Section 8.1 on page 63 for more information on VLANs. Click VLAN in the navigation
panel to display the IEEE 802.1Q VLAN screen as shown next.
Figure 31 VLAN: VLAN Status
The following table describes the labels in this screen.
Table 12 VLAN: VLAN Status
LABEL DESCRIPTION
VLAN ID Select which VLAN you want to configure or click Create New VLAN to go to the
new VLAN configuration screen.
VLAN Status
Table
This table shows you the existing VLANs and their configurations.
VLAN ID Click on the VLAN ID to go to the VLAN edit screen.
Member Ports All the ports participating in the VLAN are listed here. The ports show up in two
different colors:
• (Orange) When the packet leaves this member port, the VLAN tag is
added.
• (Turquoise) When the packet leaves this member port, the VLAN tag is
removed.
Previous Page Click this button to view VLANs with lower identification numbers. This field is only
active if you there are more VLANs than can be displayed on one screen.
Next Page Click this button to view VLANs with higher identification numbers. This field is only
active if there are more VLANs than can be displayed on one screen.