I-Tech Company CMS 6R4 Series - Manual (Page 85)

6-21
Operation
6.6.4. Terminating a Direct Connect Session
To terminate a Direct Connect session, use the client Telnet program's
"disconnect" feature. The following will occur immediately upon a client
initiated disconnect:
1. The Network port is disconnected from the RS232 Port.
2. The Network session is terminated.
3. The RS232 Port is put to sleep.
Notes:
• The Sequence Disconnect Command, which is defined via the Port
Configuration menus (Section 5.5.3) cannot be used to terminate a
Direct Connection.
• Any CMS-6R4 port that has accessed Command Mode using a
password that permits access to Supervisor Level commands can
terminate a direct connection at another port by issuing the /D
command as described in Section 6.2.3.2.
• Acknowledgment of data received by the CMS-6R4 network port
does not indicate that the data has been completely sent out the
serial port. Data may still be queued in the CMS-6R4 buffers.
Any data queued in the CMS-6R4 at the time of a client initiated
disconnect is discarded, and is not passed through to the attached
device.