I-Tech Company CMS 6R4 Series - Manual (Page 113)

10-15
Command Reference Guide
/X Exit Command Mode
Exits command mode. When issued at the Net Port, also ends the Telnet
session. Note that exiting from command mode will not terminate port
connections.
• Any-to-Any Mode: Exits command mode.
• Modem Mode: Disconnects and resets modem, hang-up message is sent,
hardware line to modem drops for 500 ms, and reset message is sent.
Availability: Supervisor / Non-Supervisor
Format:
/X[,Y] [Enter]
Where ,Y is a command argument that can be used to suppress the
command confirmation prompt.
Response:
Verbose: Disconnected.
Terse: 3.
^X Resident Disconnect Sequence
The Resident Disconnect Sequence is used to disconnect your resident port
from another port as described in Section 6.2.3.2. Although the default
Resident Disconnect Sequence is ^X ([Ctrl] plus [X]), the command can be
redefined via the Port Configuration Menus as described in Section 5.5.
Note: The Resident Disconnect Sequence cannot be used to terminate
a Direct Connection.
Availability: Supervisor / Non-Supervisor
Format (Default):
^X
Response:
Verbose: The CMS-6R4 will send the "Disconnected" message, followed
by the Port Status Screen.
Terse: 3