I-Tech Company CMS 6R4 Series - Manual (Page 69)

6-5
Operation
6.2.2. Switching Outlets - Text Interface
To switch or default outlets, or initiate a Boot Cycle, proceed as follows:
1. Switch Outlet(s) On: To power-on an outlet, type /ON n and press
[Enter]. Where " n" is the number or name of the desired outlet.
For example:
/ON 1 or /ON ROUTER
2. Switch Outlet(s) Off: To power-off an outlet, type /OFF n and press
[Enter]. Where " n" is the number or name of the desired outlet. Note
that the " /OFF" command can also be entered as "/OF". For example:
/OFF 2 or /OF ROUTER
3. Boot Outlets(s): To initiate a Boot cycle, type /BOOT n and press
[Enter]. Where " n" is a the number or name of the desired outlet. Note
that the " /BOOT" command can also be entered as "/BO". For example:
/BOOT 1 or /BO ATMSWTCH
4. Set Outlets to Power Up Defaults: Type /DPL and press [Enter]. All
outlets will be set to their default On/Off status, which is defined using the
Plug Parameters Menu as described in Section 5.5.5.
5. Suppress Command Confirmation Prompt: To execute a Boot/On/Off
command without displaying the "Sure?" prompt, include the " ,Y" option
at the end of the command line. For example:
/ON,Y ROUTER or /BOOT,Y 2